Skip to content

Gripora Gripora

Gripora

Gripora is open-source stability-control firmware for RC cars -- a gyro controller that keeps the car pointed where you steer it -- along with the Gripora Configurator used to set it up. The planned feature set covers steering stabilization, ABS braking, traction control, and launch control.

Gripora was just forked from WingFlight

Gripora was forked from WingFlight, a fixed-wing flight controller, and the conversion to cars has only just started. The documentation below still describes the fixed-wing functionality Gripora inherited from WingFlight -- flight modes, control surfaces, aircraft setup and so on. It will be rewritten as the car features land. Until then, treat it as a description of the inherited code, not of what Gripora will do on a car.

Gripora builds on the work of WingFlight, which is itself a fork of Rotorflight, which in turn derives from Betaflight. It keeps their MSP protocol, CLI, and configuration philosophy.

Early-stage project

Gripora is under active development. Firmware is currently distributed as numbered snapshots (0.0.x) rather than stable releases, and both the firmware and this documentation are evolving quickly. If something here is wrong or missing, please open an issue or a PR.

Where to start

  • New to Gripora? Start with Getting Started.
  • Setting up the app from a fresh install? See the Configurator section, organized tab-by-tab.
  • Want to understand a specific mode or feature (attitude hold, auto-trim, the throttle governor, etc.)? See Flight Modes & Features.
  • Looking for CLI commands or MSP details? See Reference.
  • Want to build the firmware or configurator yourself, or contribute? See Contributing.

Getting help

Join the WingFlight Discord for setup help, tuning advice, and project discussion.