Getting Started¶
This section walks through going from a blank flight controller to a configured, flying aircraft.
- Install the Configurator -- either as a desktop app, or use the web version at cfg.gripora.org with no install required.
- Flash the firmware onto your flight controller.
- Make a first connection and confirm sensors, receiver, and basic setup are working.
- Read Safety before you power the aircraft with a propeller fitted, and set up your receiver's failsafe.
- Set up your aircraft with the Setup Wizard: receiver, airframe, servos, motor and flight modes for your specific airframe.
- Once you have a working setup, take a backup before you start tuning.
If you get stuck at any point, the WingFlight Discord is the fastest place to get help.